PP Float Level Switch 10A 250V 0.1MPa Float Switch Water Level Controller

PP Float Level Switch

Product description

DX water pump float switch is widely used to control the liquid level.

Our float switch quality is stable, safe, and pass CE approval.Flaot Switch's operation voltage is 220vac, and current can be up to 10A. Applies to branch water,sewage,aid-base solution and oil.float switch make use of mercury switch as contact component. When liquid lift up to contact float, the float will have variable angles. The switch will have ON or OFF contact signal output when the angle is larger than 10 Degree.
1.Simple construction,reliable performance of cable float switch/water pump, tank float switch

The product can output stable and reliable switch control signal of "of making", breaking "without any fault action,so its eliability is very high and antiinter-ference is strong .

2. Sturdy and durable,need not maintain of cable float switch/water pump, tank float switch

The product can be used for a long time after it being installed.Almostno maintence and repairing problem would occur during its operation period.

Product details

1. Good material

The use of high purity copper wire, thick wire core, enough to achieve small resistance, less heat.

2. heat conduction

Environmental protection PP shell, non-toxic, tasteless, with good electrical conductivity and insu.

3. Heavy hammer principle

Hammer with working principle diagram for easy debugging and installation.

Installation

Use the black and blue wire.

when the float is on the level surface,the contact is under the obstructed status,when the float is under the water,the contact is turn-on status;

Use the black and yellow wire

When the float is on the level surface,the contact si turn-on status,when is under the water,the contact is the obstructure status;

Installation of fixed hammer

The level control height is decided by the cable length of magnetic float type level switch and the position of the hammer;

The ways of install the hammer

Displace snap ring of the plastic non-cone terminal,and to the appropriate place on the cable.

Then let the cable penetrate the terminal of the plastic cone,the snap ring of set on the cable limit the position of the hammer;

Finally,fixed the cable outside of the container,let the cable connect to control box and avoid using middle joint.if it need joint forbid to put the joint in he water.

Specification

Wiring system

Packaging Display